SAE J1939 to USB Gateway for ECU and Data Traffic Simulation

SAE J1939 ECU Simulator Board With USB Port

Our SAE J1939 gateway allows you to monitor, simulate, and record any PGN as defined in the SAE J1939-71 Standard but also including diagnostic messages according to SAE J1939-73. Many users ask us whether or not we can process specific parameters such as fuel consumption, vehicle speed, vehicle position, etc., and the answer is always yes. However, you need to understand that the gateway was not designed for specific engine parameters, i.e., you need to know which PGN represents the desired data. Also, the gateway was not designed to simulate specific diesel engines, but if you enter all PGNs that are being used, you can design and simulate any diesel engine.

Purchase at:
SAE J1939 ECU Simulator Board For PC, Raspberry Pi, BeagleBone, Arduino, Teensy, Linux, Windows (copperhilltech.com)

Previous Story

SAE J1939 Software & Hardware for Fleet Management Systems

Next Story

SAE J1939 – GPS Module Reports Vehicle Position, Speed & Direction